Wie baue ich eine Jurte auf?/en: Unterschied zwischen den Versionen

Zur Navigation springen Zur Suche springen
Die Seite wurde neu angelegt: „Easiest way to do this is when bring don the roof again. Standing on the ground the smoke hole around your shoulders you can easily tie the cap in. Ensure tha…“
(Die Seite wurde neu angelegt: „First you have to decide how huge or small the gap between cap and smoke hole should be. Do you want the cap to close the whole smoke hole (as leak proof as po…“)
(Die Seite wurde neu angelegt: „Easiest way to do this is when bring don the roof again. Standing on the ground the smoke hole around your shoulders you can easily tie the cap in. Ensure tha…“)
Zeile 75: Zeile 75:
The answer causes the decision where you are going to set the lashing point which is ideally the spot where you place the roof cap.
The answer causes the decision where you are going to set the lashing point which is ideally the spot where you place the roof cap.


Und das geht eben am besten, wenn das Dach herabgelassen ist, dann hast du bequem die Füße auf dem Boden, kannst dir das Rauchloch um die Schultern hängen und alles entsprechend vorbereiten. Die Schnüre sollten nicht verheddert sein, sonst kommst du nachher von außen schwerer dran, wenn du das Dächlein über dem Rauchloch abspannen willst.
Easiest way to do this is when bring don the roof again. Standing on the ground the smoke hole around your shoulders you can easily tie the cap in.
 
Ensure that the cords are not tangled, otherwise you‘d have trouble trying reach them from the outside once the roof is pulled up again.


Zuletzt nimmst du deine acht Schnüre und legst die mit einem Spannknoten an die entsprechenden Abspannschnüre an. Welche die richtige ist, das musst du einfach ausprobieren. In der Theorie ist es jede zweite Abspannschnur, das hängt nun aber auch ein wenig von der Anbringung ab, wie der Stoff fällt und wie sich die Abdeckplane ziehen lässt. Zum Schluss sollte auf jeden Fall ein Segment der Jurtenabdeckplane überlappend abgespannt sein.
Zuletzt nimmst du deine acht Schnüre und legst die mit einem Spannknoten an die entsprechenden Abspannschnüre an. Welche die richtige ist, das musst du einfach ausprobieren. In der Theorie ist es jede zweite Abspannschnur, das hängt nun aber auch ein wenig von der Anbringung ab, wie der Stoff fällt und wie sich die Abdeckplane ziehen lässt. Zum Schluss sollte auf jeden Fall ein Segment der Jurtenabdeckplane überlappend abgespannt sein.
19.928

Bearbeitungen

Navigationsmenü